What size subwoofer amp should i get and how should i wire them up? - subwoofer and amp installation
I bought a subwoofer setup. The speakers are two 12 "Pioneer Surface Mount. Peak 1000 watts and 200 watts RMS into 4 ohms to use. Amps, what size should I optimize everything to make power and how they must be connected get to the best of them, please . your help!
Thursday, January 14, 2010
Subwoofer And Amp Installation What Size Subwoofer Amp Should I Get And How Should I Wire Them Up?
6 comments:
I have 2 12 "shots in my trunk with a 400-watt Kenwood amp. I function quite well. Rockforfosgate is a very good system to go with them. When wiring in general, places like Best Buy, sales of these products for free . If not, then there should be instructions that come with the elements. If all else fails .... youtube it.
I have 2 12 "shots in my trunk with a 400-watt Kenwood amp. I function quite well. Rockforfosgate is a very good system to go with them. When wiring in general, places like Best Buy, sales of these products for free . If not, then there should be instructions that come with the elements. If all else fails .... youtube it.
I get to 450 or 500 watts and make sure that does RMS into 4 ohm voice coil, unless, two submarines and then get cable into 2 ohms, and an amplifier output into 2 ohms, I want to have an amplifier after the bridge piece, the two submarines for the boom that they sound good.
http://www.sonicelectronix.com/item_1179 ...
haha i donno about the wiring, but I think 4 cable performance would be better
Personally, I'm going with a good 400 watt amplifier and connected, turn down and to be .. Sony Xplod 4 ohms and not bad in my opinion.
Jackhammer subwoofer! yeahhh !!!!!!!!! Awesomeeeee
Post a Comment